Introduction to breeding fence net and how to install it

Next, before introducing the issue of how to install breeding fence nets, let’s first talk about the types of breeding fence nets.
Types of breeding fence nets: Breeding fence nets include plastic flat mesh, geogrid mesh, chicken diamond mesh, cattle fence mesh, deer breeding mesh, breeding Dutch mesh, pig bottom mesh, plastic dipped welded mesh, aquaculture cage, There are many types of breeding hexagonal nets, with different types and different breeding uses.

How to install breeding fence nets: There are many types of breeding fence nets, their application locations are also different, and their installation methods are also different. Let’s introduce them one by one.
The plastic flat net can be used as a flat bottom. For specific use, it can be tied with 22# tie wire, but it is best to tie it with easy-pull plastic tie wire; it can also be fixed on the pillars or with the surrounding fence. Used in combination with other breeding fence nets.
Geogrid mesh is mostly used for surrounding enclosures and is tied with iron wire or string. When tying it, you should pay attention to it densely because it is relatively soft and does not have much support, so it is easy to create gaps. This is a bad place. , is also one of its own flaws, just pay attention to overcome it.
Pig bottom net is a kind of net commonly used in raising pigs. It is also a kind of bottom net that is often used in other breeding and plays a supporting role. The mesh is slender, usually 1.5-2.5 cm wide, 6 Centimeter-long rectangular woven holes are used to facilitate the discharge and removal of farmed animal feces. When this kind of net is used in a large area, the bottom can be fixed on the support, and the edges can be welded or tied to the surrounding fence; when used in a smaller space, it can be laid directly on the bottom and fixed all around.
The usage conditions of cattle fence net and deer net are basically the same, so we will introduce them together. A vertical column can be set up every 5 to 12 meters, a center column can be set up every 5 to 10 small columns, and a T-shaped ground anchor can be set up, buried about 60 centimeters. In addition, at each corner Install a large column. The small column is 40×40×4mm; the middle column is 70×70×7mm; the large column is 90×90×9mm. The length can be adjusted according to the situation, generally as follows: small column 2 meters; middle column 2.2 meters; large column 2.4 meters.

The installation conditions of chicken diamond mesh, plastic dipped welded mesh, Dutch breeding mesh, and hexagonal mesh are basically the same. There is a column every 3 meters or so. The column can be a special column used by the manufacturer, or a small tree taken from the local area. , wooden piles, bamboo poles and other objects are often pre-embedded during installation, which is also more convenient. After installing the uprights, pull out the net that needs to be installed (usually in a roll) and fix it on the uprights while pulling it. You can use special buckles for breeding fence nets or wire binding. Each upright will be tied three times. That's enough. Pay attention to the bottom to be a few to ten centimeters away from the ground and not to completely touch the ground. Also add diagonal braces at each corner.

chicken wire mesh (55)
chicken wire mesh (30)

Post time: Nov-23-2023